Extrusion Granulation + Drying Production Line Successfully Launched in Pakistan

Production Line Configuration and Core Process Analysis The entire production line is built around the core logic of "raw material pretreatment - extrusion granulation - low-temperature drying - finished product output." Equipment selection is tailored to regional conditions, and the processes are tightly and efficiently integrated, ensuring both high granulation rate and product quality upgrades through precise humidity control. Raw Material Pretreatment and Extrusion Granulation Unit: Laying a Solid Foundation for Forming Raw Material Refinement: The production line starts with a large-capacity loader feeding hopper, adapting to the rapid feeding needs of bulk raw materials. The feed inlet is equipped with spill prevention and impurity filtration devices to reduce raw material loss and equipment failure risks. Raw materials are transferred via a conveyor system to a 60-type crusher (presumably a "60-type horizontal semi-wet material crusher"). This equipment adopts a two-stage crushing structure, with a high-chromium wear-resistant alloy cutter disc, capable of crushing large, agglomerated raw materials (particle size ≤80mm) into uniform fine materials ≤3mm, achieving a crushing efficiency of 4 tons/hour, providing a high-quality raw material foundation for subsequent granulation. The crushed raw materials are then fed into a twin-shaft mixer via a belt conveyor, where they are thoroughly mixed by counter-rotating blades, with a mixing uniformity error ≤2%, ensuring balanced fertilizer nutrients. High-efficiency extrusion granulation: The mixed raw materials are precisely fed to the core granulation equipment—multiple 2.0-type double-roller extrusion granulators (estimated based on the project's standard configuration). This model features a high-strength double-roller design; the roll skin is hardened to a hardness of HRC60 or higher, exhibiting extremely high wear resistance. The equipment precisely controls the extrusion pressure (8-15MPa) through a hydraulic pressurization system, adapting to the granulation needs of raw materials with varying moisture content (25%-32%). The granulation rate remains consistently above 92%, with uniform particle size controlled at 3-5mm and an initial particle strength of 2.0MPa, providing a solid foundation for subsequent drying. Multiple granulators operate in parallel, with a total capacity of up to 6 tons/hour, meeting the needs of large-scale production. Core Drying Unit: Precise Humidity Control Enhances Quality After granulation, the wet granules are transferred via an 8-meter belt conveyor (the document "128-meter belt conveyor" is presumably a typo) to a 1.5×5-meter dryer (the document "1115×5-meter dryer" has been corrected). This equipment is the core of the production line's quality control, employing a sleeve-type hot air circulation design with an optimized airflow layout for Pakistan's dry climate, improving heat exchange efficiency by 18%. The dryer is equipped with a dedicated hot air furnace (a supplementary component to the essential drying process), allowing for precise temperature control (60-90℃). Through a low-temperature, slow drying process, the granule moisture content is reduced from approximately 30% to below 12%, preventing high-temperature damage to fertilizer nutrients and ensuring granule hardness reaches over 2.5MPa, effectively preventing pulverization and clumping during storage and transportation.

Click to Visit Site