High-efficiency molding! 4m³/hour sodium carbonate extrusion granulation production line
The sodium carbonate (soda ash) extrusion granulation production line focuses on the solidification and molding needs of powdered sodium carbonate. With "precise pretreatment - high-pressure extrusion - grading and screening - finished product output" as its core process, it achieves a stable production capacity of 4m³/hour (approximately 6.8 tons, based on a sodium carbonate density of 1.7g/cm³) through customized equipment configuration and process optimization. The finished granules are characterized by high strength, good flowability, and low moisture absorption, making them suitable for applications in chemical, building materials, and environmental protection industries. Production Line Configuration and Core Details I. Raw Material Pretreatment Unit: Ensuring Basic Granulation Quality (I) Raw Material Storage and Feeding System Raw Material Silo: Equipped with one 10m³ conical raw material silo, made of 304 stainless steel (resistant to slight corrosion from sodium carbonate). The silo has a 60° cone angle and is equipped with a vibrator and a star-shaped unloader at the bottom to prevent powder bridging and blockage. The raw material silo is equipped with a pulse dust collector at the top to collect dust generated during the feeding process. The dust emission concentration is ≤10mg/m³, meeting environmental protection standards. Quantitative feeding device: A variable frequency controlled screw feeder (model LS300) is used, with the feeding rate precisely adjustable within the range of 2-5m³/h, suitable for a production capacity of 4m³/h. The feeder shell adopts a sealed design, and the internal spiral blades are treated with a wear-resistant coating to reduce wear on the equipment caused by sodium carbonate powder and prevent moisture absorption and agglomeration. (II) Raw material drying and crushing pretreatment Low-temperature dryer: Because sodium carbonate is prone to moisture absorption and agglomeration, one Φ1.2×6.0 meter drum dryer is configured. Hot air circulation heating is used, and the drying temperature is controlled at 80-100℃, reducing the raw material moisture content from ≤5% to ≤0.5%, avoiding agglomeration that affects extrusion molding. The dryer has a built-in lifting plate spiral layout, ensuring uniform heating of the material, with a drying uniformity error of ≤2%. Fine Pulverizer: A 400-type vertical pulverizer is selected, with a cutter disc made of high-chromium wear-resistant alloy. It pulverizes any lumps (particle size ≤20mm) that may exist after drying into uniform powder ≤1mm, ensuring consistent raw material fineness and improving extrusion granulation rate. The pulverizer is equipped with a grading screen, allowing flexible adjustment of the discharge particle size. The pulverizing efficiency reaches 6m³/h, meeting the continuous operation requirements of the production line.
Click to Visit Site