Fertilizer Granulation: Key Points in Raw Material Selection and Pretreatment

Core Common Requirements for Raw Materials Whether using a disc granulator or a rotary drum granulator, raw materials must meet the following basic conditions: First, the particle size of raw materials should be controlled within a fine range, generally recommended between 80 and 200 mesh (approximately 75–150 micrometers). Fine powdered materials provide a larger contact area between particles, facilitating stable bonding during granulation. Overly coarse particles (e.g., larger than 1 millimeter in diameter) or lumpy impurities can not only affect the uniformity of granules but may also cause equipment clogging or wear. Second, the moisture content of raw materials is a critical factor for successful granulation. Typically, the base moisture content of raw materials should be maintained between 10% and 20%, with specific values varying depending on the type of fertilizer. If the moisture content is too low, granules may not form properly, requiring the addition of water or binders through the equipment's spraying system. Excessive moisture, on the other hand, can lead to clumping and uneven granulation. Stable moisture content is essential for ensuring the strength and durability of the final granules. Additionally, raw materials must possess a certain degree of natural adhesiveness or achieve the required bonding effect through the addition of binders. Completely non-adhesive inert powders (such as quartz sand) cannot be directly used for granulation. Commonly used binders include water, bentonite, starch, cellulose derivatives, and ammonium phosphate solutions. The choice of binder depends on the type of fertilizer: organic fertilizers often use bentonite, while compound fertilizers typically employ ammonium phosphate solutions. Finally, the raw materials must not contain hard, sharp impurities such as metal fragments or stones. These impurities can not only scratch the inner walls of the equipment (especially the wear-resistant linings of discs and rollers), but may also damage transmission components and affect the normal operation of the equipment.

Click to Visit Site